[. . . ] 4 CM) RANGE HOOD Installation Instructions and Use & Care Guide For questions about features, operation/performance, parts, accessories or service, call: 1-800-253-1301 or visit our website at www. Com In Canada, for assistance, installation and service, call 1-800-807-6777 or visit our website at www. 32 RANGE HOOD SAFETY Your safety and the safety of others are very important. We have provided many important safety messages in this manual and on your appliance. [. . . ] Determine and clearly mark a vertical centerline on the wall and cabinet in the area the vent opening will be made. 1 cm) from the back wall on the centerline of the underside of cabinet. 3 cm) to the right and left of the centerline on the underside of cabinet. 3 cm) To make a circular vent opening on the underside of the cabinet top: 1. Use a compass or a circle template to draw a circle with a diameter that is ¼" (0. 7 cm) *From wall, not cabinet frame Wall Venting To make a 3½" x 10½" (8. 8 cm) down from underside of cabinet and mark on the centerline on the back wall. Use saber or keyhole saw to cut a rectangular opening in the wall for the vent. Centerline Cabinet front Cabinet cutouts *From wall, not cabinet frame Style 3 - Cut Openings for 7" (17. 8 cm) Round Vent To make a circular vent openings on the underside of the cabinet top and bottom: 1. 7 cm) from the back wall on the underside of the top and bottom of cabinet. Use a compass or a circle template to draw a circle with a diameter that is ¼" (0. For optional power supply cord kit installations, follow the instructions in the “Make Electrical Connection” section. See the “Accessories” section for information on ordering. NOTES: ■ B A C D E ■ Use only with range hood cord connection kits that have been investigated and found acceptable for use with this model range hood. Horizontal vent connector with damper A B ■ If a vent damper is installed with a wall cap with damper, check that they do not interfere with each other. Remove the power supply knockout from the top or rear of the vent hood (depending on the incoming location of your home power supply cable) and install a UL listed or CSA approved ¹⁄₂" strain relief. Feed enough electrical wire through the ½" UL listed or CSA approved strain relief to make connections in the terminal box. Position the range hood so that the large end of the keyhole slots are over the mounting screws. Then push the hood toward the wall so that the screws are in the neck of the slots. Tighten the mounting screws, making sure the screws are in the narrow neck of slots. Seal joints with vent clamps or duct tape to make secure and airtight. [. . . ] This limited warranty is effective from the date of original consumer purchase. Proof of original purchase date is required to obtain service under this limited warranty. Commercial, non-residential, multiple-family use, or use inconsistent with published user, operator or installation instructions. Service to correct improper product maintenance or installation, installation not in accordance with electrical or plumbing codes or correction of household electrical or plumbing (i. [. . . ]